EasyManua.ls Logo

Lonking CDM853 - 5.8 USEOFFUELSYSTEMANDRELATEDMAINTENANCE

Lonking CDM853
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
129
found over
it
or gasket or seal is damaged, replace
it
with a new coarse filter.
7. Install the clean coarse filter into the air filter shell to ensure the even contact of the
sealing part
at
the end of the coarse filter.
8. Cleanand install the cover of air filter, tighten the cover with hand and fasten the end
cover.
9. Press the indicator to reset the indicator.
If the engine starts, the yellow piston of air filter indicator moves to the red area, or the
engine produces black smoke, with power dropping down,it requires replacing with a new
coarse filter. Inspect the air filter maintenance indicating lamp or
at
an
y
time, clean the
coarse filter regularly (when the indicating lamp lights up) and replace (every 1000 hours).
If the working environment and areas are very harsh, thenthe cleaning and replacement
cycle are shortened, depending on the situation.
5.6.7
5.6.7
5.6.7
5.6.7 CLEAN
CLEAN
CLEAN
CLEAN DUST
DUST
DUST
DUST COLLECTION
COLLECTION
COLLECTION
COLLECTION CUP
CUP
CUP
CUP OF
OF
OF
OF THE
THE
THE
THE AIR
AIR
AIR
AIR FILTER
FILTER
FILTER
FILTER
Dust collection cup is for collecting the dust and water inside the air filter, press the dust
cup regularly, and drain out the water and dust.
1.
1.
1.
1. When
When
When
When the
the
the
the air
air
air
air filter
filter
filter
filter element
element
element
element is
is
is
is broken,
broken,
broken,
broken,
it
it
it
it
must
must
must
must be
be
be
be replaced.
replaced.
replaced.
replaced.
2.
2.
2.
2. Conduct
Conduct
Conduct
Conduct the
the
the
the maintenance
maintenance
maintenance
maintenance on
on
on
on air
air
air
air filter
filter
filter
filter periodically
periodically
periodically
periodically according
according
according
according to
to
to
to the
the
the
the requirement
requirement
requirement
requirement
of
of
of
of the
the
the
the air
air
air
air filter
filter
filter
filter maintenance
maintenance
maintenance
maintenance instructions.
instructions.
instructions.
instructions.
3.
3.
3.
3. In
In
In
In case
case
case
case of
of
of
of maintenance,
maintenance,
maintenance,
maintenance, do
do
do
do not
not
not
not pollute
pollute
pollute
pollute the
the
the
the internal
internal
internal
internal side
side
side
side of
of
of
of the
the
the
the filter.
filter.
filter.
filter.
4.
4.
4.
4. Do
Do
Do
Do not
not
not
not start
start
start
start the
the
the
the engine
engine
engine
engine with
with
with
with air
air
air
air filter
filter
filter
filter or
or
or
or air
air
air
air filter
filter
filter
filter element
element
element
element disassembled.
disassembled.
disassembled.
disassembled.
5.8
5.8
5.8
5.8 USE
USE
USE
USE OF
OF
OF
OF FUEL
FUEL
FUEL
FUEL SYSTEM
SYSTEM
SYSTEM
SYSTEM AND
AND
AND
AND RELATED
RELATED
RELATED
RELATED MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
5.8.1
5.8.1
5.8.1
5.8.1 FUEL
FUEL
FUEL
FUEL TANK
TANK
TANK
TANK CLEANING
CLEANING
CLEANING
CLEANING
Removal of moisture and impurities from fuel:
1. If conditions permit, diesel shall be allowed to settle for 24 hours before being filled into
fuel tank.
2. Before oil filling, unscrew the drain plug on the bottom of fuel tank once every week to
remove moisture and impurities
at
the bottom of fuel tank.
3. After end of daily work, fill up the fuel tank with diesel to remove moisture from fuel tank .
4. After each filling up of fuel tank, keep still for 5~10 minutes so that moisture and
impurities in diesel will settle
at
the bottom of fuel tank.
5. After end of daily work, unscrew the drain plug
at
the bottom of diesel pre-filter, primary
diesel filter and secondary diesel filter to remove moisture and impurities.
Repeat the above steps till the drained oil is clean.
Warning
Warning
Warning
Warning

Table of Contents