EasyManua.ls Logo

Lonking CDM853 - 1.8.16 TREATMENTOFABNORMALSTATUS; 1.8.17 FILLOFFUELORLUBRICATINGOIL

Lonking CDM853
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
that have risk of ignition. Thus,
it
is necessary to avoid welding in such a place.
If the welding sparks flying directly onto rubber hoses, wires or pipes with pressure,
these tubes may suddenly rupture and wire insulation skin may be damaged, so
it
is
necessary to cover these things with fire flapper.
Wear protective clothing during welding operation.
Keep the welding work site well ventilated.
Clean all flammable materials before welding, and equip with fire extinguishers on the working site.
1.8.15
1.8.15
1.8.15
1.8.15 PRECAUTIONS
PRECAUTIONS
PRECAUTIONS
PRECAUTIONS FOR
FOR
FOR
FOR BATTERY
BATTERY
BATTERY
BATTERY MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
The negative pole (-) of the battery must be disconnected when the electrical system is
repaired or electric welding operation is performed on the machine, so as to prevent
current flow.
1.8.16
1.8.16
1.8.16
1.8.16 TREATMENT
TREATMENT
TREATMENT
TREATMENT OF
OF
OF
OF ABNORMAL
ABNORMAL
ABNORMAL
ABNORMAL STATUS
STATUS
STATUS
STATUS
If any abnormal status is found during overhaul, repair it. Especially that when the
machine is in operation, there is any irregularity in braking system, steering system or
working device system, which can lead to serious accidents.
Please consult the designated dealer of LONKING Holdings Limited for repair according
to the fault types.
1.8.17
1.8.17
1.8.17
1.8.17 FILL
FILL
FILL
FILL OF
OF
OF
OF FUEL
FUEL
FUEL
FUEL OR
OR
OR
OR LUBRICATING
LUBRICATING
LUBRICATING
LUBRICATING OIL
OIL
OIL
OIL
Fuel, lubricating oil, hydraulic oil, antifreeze,
brake fluid, window glass detergent can be
ignited by flame. Therefore please comply with
the following provisions:
When filling fuel or lubricating oil, close engine
No smoking.
Overflowed fuel, lubricating oil, hydraulic oil,
antifreeze, and brake fluid or window glass
detergent should be cleaned up immediately.
All top caps of container of the fuel, lubricating oil ,
hydraulic oil, antifreeze, braking fluid and
window glass detergent should be tightened
firmly.
Place of filling or storing of fuel, lubricating oil,
hydraulic oil, antifreeze, brake fluid or window
glass detergent should be well-ventilate.

Table of Contents