Park the machine on the even ground, and then
lower working device down to the ground where
there should no falling rocks or sliding danger,
and there also should no flood if it is low terrain.
If it is necessary to park the machine on the
slope, place a wedge under the wheels to
prevent the machine moving, and then drop the
working device down to the ground.
When parking the machine on the road, it is
necessary to set up fences, signals, flags or
warning lights and other necessary signals to
ensure the machine can be seen clearly.
However, the machine, fences and flag shall not
affect other vehicles passing t hrough the road.
Before leaving the machine, fully lower the
bucket down to the ground, lock up joystick with
locking device, shut down the engine, and pull up
the parking brake switch to the “ brake ” position.
Lock all equipments with keys, and remove and
carry the keys.
When loading or unloading machine, the engine
should be ran at low speed, while the machine
should walk at low speed.
Loading or unloading of the machine should
progress on solid and even ground, and keep a
safe distance from the roadside.
Fix the carrying truck when loading or unloading
the machine, and place a pad block under the
springboard.
Use inclined plates with enough strength, width
and length to provide a safe loading or unloading
slope. The oblique angle between slant plate and
ground shall not exceed 15 ° . The distance
between the slant plates shall be compatible with
machine ’ s wheelb ase
Firmly fix the position of slant plate, and make
sure they have the same height.
To Next Page
Loading...