melt the battery electrolyte prior to starting, and inspect whether there is any leakage.
2. Inspect the battery shell
Do not add more power if the battery case cracks or leaking battery acid, identify the
reason then replace the battery.
3. Inspect the liquid level of battery
The installed battery is of maintenance-free type, without the necessity to add the battery
electrolyte (distilled water) to the battery cell. When the charging indicator turns gray,
it
shows that the electrolyte is insufficient, probably due to leakage o r the failure of charging
system. Must find out the fault and replace the battery.
4. Inspect the charging state
Inspect the charging status
by
reviewing the indicating inside the device.
1) Green: Normal.
2) Black: Charging is not sufficient.
3) Pale: No longer available and cannot charge.
5. Inspect the battery terminals
1) The battery has the terminals broken cannot be recharged, investigate the reason
before replace the battery;
2) When there are any oxide surfaces over the terminals, please remove the oxide
surfaces and clean the terminals before charging.
5.9.2
5.9.2
5.9.2
5.9.2 INSPECT
INSPECT
INSPECT
INSPECT ELECTRICAL
ELECTRICAL
ELECTRICAL
ELECTRICAL DEVICES
DEVICES
DEVICES
DEVICES
1. Inspect in cold weather
In cold weather, remove the water, snow or mud covered on the wire, cable plug
connectors, switches, or sensors, as well as those parts, to avoid parts failures;
2. Inspect lighting equipment, etc.
1) First inspect the lights, horn, wiper and other electrical components to find out whether
they are fault-free or not;
2) If there is any error, then inspect the corresponding fuse to find out whether there is
any error according to the schematic, if there is any error, replace it;
3) If the relevant fuse has no error, then inspect the electric cable of each electric parts
with the entire vehicle charged with electricity, to inspect whether there is 24V voltage,
if no voltage, then inspect the power cable between electrical parts and t he fuse is
broken or not;
4) If the voltage is measured, please replace the relevant electric parts.
3. Inspection of Instrument and equipment
To Next Page
Loading...