PyroTec™ PRO Hardw are User’s Manual, V1.2 86
RT-MN024-1.2 02/21
Weekly
Maintenance
Liquid handling arm,
Robotic manipulator arm,
Air displacement
pipetting arm (Air LiHa)
Perform the following tests:
• Pressure Leak Test
See PyroTec™ PRO Software
User Guide
The weekly maintenance should be performed on the last working day of each week.
9.2.4 Maintenance Table: Yearly Maintenance
Annual maintenance will be performed by a Lonza approved FAS (field application specialist)
and be offered through a service contract. Reference material for the maintenance tasks
can be available upon request.
Months
Air displacement pipetting
arm (Air LiHa)
performance verification test
(Colorimetric QC Kit test or Gravimetric test)
Visually inspect worktable grids for wear and replace
if necessary.
Visually inspect moving parts, especially Y-belt and lower DiTi eject
option, for wear and replace faulty parts.
Check parts for abrasion; wipe wear debris off, if necessary.
Check condition of mesh (must not be broken).
Check if support-tubing ends lock firmly in their seats.
Replace defective support tubing.
DiTi cone and tubing ex-
tension
Air LiHa; DiTi cone tip
adapter
Replace option DiTi cone Air LiHa
Visually inspect moving parts, especially Y-belt, for wear and replace
faulty parts.
Check parts for abrasion; wipe wear debris off, if necessary.
Perform tests according to form “Preventive Maintenance”
To Next Page
Loading...
