Lonza PyroTec PRO - Configuration Data; Air Liha Configuration

Return to TOC
PyroTec™ PRO Hardw are User’s Manual, V1.2 28
RT-MN024-1.2 02/21
Pipetting
Conditions
Pipetting temperature
20°C to 27°C (68°F to 80.6°F)
Pipetting humidity
30% to 60% relative (non-condensing) at 25°C (77°F) or be-
low
Storage
Conditions
Storage temperature
1°C to 60°C (34°F to 140°F)
Storage humidity
5% to 80% relative (non-condensing) at 30°C (86°F) or below
Transport
Conditions
Transport temperature
-20°C to 60°C (-4°F to 140°F) for maximum 24 hours
Transport humidity
20% to 80% relative (non-condensing) for maximum 24 hours
Emissions
Noise emission
(EN61010-1)
< 85 dBA [61.3 dBA (sound pressure), measured at a dis-
tance of 1 m from the instrument]
4.2 Configuration Data
Upgradeability
An existing PyroTec™ PRO instrument can be upgraded with a Front-Loading ID (barcode
scanner) that can be installed later after the initial installation.
Field upgrades can be performed by a Lonza approved FAS (field application specialist)
only.
Delivery
The PyroTec™ PRO is delivered only to a Lonza approved FAS (field application specialist),
who take responsibility for assessing and investigating each installation at an end-user site
to comply with local requirements.
4.2.1 Air LiHa Configuration
The Air LiHa can be used on:
• PyroTec™ PRO: The Air LiHa is always equipped with a lower DiTi eject device and fea-
tures the Air LiHa MultiSense functions.