76
Remote Viewing
Configuring PTZ Parameters
The system is capable of manipulating PTZ cameras (not included) that are connected to
the system. Please note that you will need PTZ information from the PTZ manufacturer’s
users guide.
To configure PTZ settings:
1 Cl
ick Remote Setting>Device>PTZ Parameters.
2 Co
nfigure the following:
• Channel: Sel
ect the channel that the PTZ camera connects to
• Protocol: Select the protocol of the PTZ camera*
• Address: Select the address of the PTZ camera*
• Baud Rate: Select the baude rate of the PTZ camera*
• Data Bit: Select the data bit rate of the PTZ camera*
• Stop Bit: Select the stop bit rate of the PTZ camera*
• Verify: Select from Odd, Even, Mark, or Space.*
*Consult the PTZ camera’s instruction manual for protocol and configuration details
Optional: Cl
ick the Copy Settings To button to copy the PTZ settings to different channels.
3 Cl
ick Apply to save your settings.
For details on connecting a PTZ camera to your
system, see “Appendix H: Connecting a PTZ
Camera” on page 112.
To Next Page
Loading...
Need help?
General
