Lorex LNC216 Series - Camera Info Tab

93
L-View for Mac
English
3. Click Update to save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. Click OK to exit the settings window.
NOTE: The camera may reboot after settings are changed. Wait about 30 seconds and
t
hen double-click the camera in Camera List or Auto Search to reconnect to the camera.
To configure motion detection sensitivity:
NOTE: T
he following method works when using video motion detection. It does not work
when using PIR motion detection. For details on enabling motion detection and selecting
video motion detection or PIR, see “Schedule” on page 180.
1. Right-click the camera in Camera List and click Video settings. Then
, select the
Control tab.
2. Under Motion Detection Sensitivity, sel
ect the motion detection sensitivity between
1 (High) and 10 (Low). If Motion Detection Sensitivity is set to 1, motion detection will
be triggered if a moving object is larger than 1% of the video area. If it is set to 10, a
moving object must be larger than 10% of the video area to trigger motion detection.
3. Click Update t
o save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. Click OK to exit the settings window.
NOTE: The camera may reboot after settings are changed. Wait about 30 seconds and
t
hen double-click the camera in Camera List or Auto Search to reconnect to the camera.
5.6.4 CAMERA INFO TAB
The camera info tab shows system information about the camera.
To access the camera info tab:
• Right-click on the camera in Camera List and select Vi
deo Settings. Then select the
Camera Info tab.