Lorex LNC216 Series - Connecting to Your Camera on Mac; Basic Setup

34
Getting Started
2.5 CONNECTING TO YOUR CAMERA ON MAC
Follow the steps below to get up and running on a Mac computer.
2.5.1 BASIC SETUP
1. Connect the power adapter cable to the power adapter using the USB connector.
2. Connect the power adapter to a surge protector or power outlet. Connect the power
adapt
er cable to the DC/IN port on the camera. The camera LED’s will begin flashing.
3. A: Con
nect an Ethernet cable (included) to the NET port on the camera and connect
the other end to an available LAN port (usually numbered 1~4) on your router (not
Power Adapter
Power Adapter Cable
1
2