35
Getting Started
English
included). The blue Network LED on the camera will glow blue when the camera is
connected to your network.
• For instructions on setting your camera up f
or WiFi, see “Mac WiFi Setup” on page 39.
OR:
B: OPTIONAL: If your router supports WPS, press and hold the WP
S button on your
router until the WPS light turns on. Then, press the WPS button on the camera within 1
minute. The camera will automatically connect to your WiFi network and the blue
Network LED on the camera will turn on.
NOTE: Not all routers support WPS, and the location of the WPS button on your router
depends on your router model. Check your router’s instruction manual for details.
3B
Press and hold the WPS button
on the router
Then, press the WPS button
on the camera
To Next Page
Loading...
