64
L-View 116 for PC
3. Under Place, select Outdoor video if the area with the camera is brightly lit. Select
Indoor Video if you notice strip lines in the image or if the picture is too dark on the
Outdoor video setting. Select Indoor video + Sunlight if the picture is too bright on
the Indoor Video setting.
• If you select Indoor Video or Indoor Video + Sunlight, sel
ect 60Hz or 50Hz to adjust
the camera for the frequency of your indoor lighting.
4. Under Video Flip, sel
ect Video Flip to flip the camera image vertically and
horizontally or select Normal for normal orientation.
5. Under Brightness, sel
ect the brightness of the image between 10 (highest) and
1 (lowest).
6. Under Lo
w Light Sensitivity, set the camera’s sensitivity in low light environments
between Very High (highest), High, and Normal (lowest).
7. Check Enabl
e time display on video to turn on video time stamps or un-check it to
disable video time stamps.
8. Under Micr
ophone, select Enabled to enable the built-in microphone on the camera
or select Disabled to disable the built-in microphone on the camera.
9. Click Update t
o save changes. Enter the camera admin user name (default: admin)
and password (default: left blank) and click OK. The camera will disconnect. Wait
about 15 seconds and then double-click the camera in Camera List or Auto Search to
reconnect to the camera.
3.8.3 CONTROL TAB (CONFIGURE STATUS LED’S AND MOTION
DETECTION SENSITIVITY)
The Control tab allows you to configure the camera status LED’s to make the camera
Configure status LED’s
Configure motion detection
sensitivity from 1 (High) to 10 (Low)
To Next Page
Loading...
