179
Configuring Camera Settings using a Web Browser
English
Before you can record to a NAS device, please make sure of the following:
1. Your NAS device must be connected to the same network as the camera and it must
be
turned on.
2. You have the admin user name and password for your NAS device. Check the
ins
truction manual for your NAS device for details.
3. You have the local IP address of your NAS device. Check the instruction manual for
y
our NAS device for details.
4. Your NAS must have an available folder in the main (root) folder for recordings to be
s
tored. This folder must be available before you begin NAS recording and it must
allow read/write access. An example of an acceptable recording folder would be
public.
To configure NAS recording settings:
1. Select one of the following:
• Al
ways Recording: Record to NAS continuously, all the time.
• Schedule Recording: Record to NAS according to the settings set in the Scheduling
page. See “Scheduling (Configuring Recording and Alarm Schedules)” on page 187.
• Disable Recording: Do not record to NAS.
2. Select one of the following:
• Keep r
ecorded video for X days (Overwrite): NAS device will keep recordings for up
to the number of days specified, and then it will overwrite the oldest recordings.
• If free disk less than X GB: NAS device will save recordings until it has less than the
specified amount of disk space remaining. If you select this option, select Overwrite
to allow the NAS device to overwrite the oldest recordings when the available space
Example of an
acceptable NAS
recording
To Next Page
Loading...
