20
Getting Started
7. Press the WPS button on the camera. The LEDs will start flashing.
8. Place your device about 1ft (30cm) away from the camera.
The camera scans the QR code on your device to connect to the WiFi network. When
the c
onnection is successful, the camera beeps, and the message below appears on
your device after a few seconds.
9. Enter a name for your camera and press OK.
10.Tap the camera to connect.
Press the WPS button
on the camera
Enter a name for
your camera
Tap the name of the
camera to connect
To Next Page
Loading...
