MERLIN LEGEND Communications System Release 6.1
System Manager’s Guide
555-661-118
Issue 1
August 1998
Managing the System
Page 6-79Revising Night Service with Coverage Control
6
Programming Instructions 6
Revising Night Service with
Coverage Control 6
In Release 4.1 and later systems, system managers can coordinate the status of
Coverage VMS Off buttons programmed at extensions with Night Service
operation.
With this feature enabled (the factory setting is disabled), the following occurs:
■ When Night Service is turned on, all Coverage VMS Off buttons are
deactivated; that is, the programmed voice-messaging system calling
group takes calls.
Console Procedures To assign a calling group to a Night Service group:
1LJKW6UYF H→*URXS$VVLJQ→&DOOLQJ*URXS→Dial ext.
no. of Night Service operator
→(QWHU→Dial calling
group no.
→(QWHU→([LW→([LW
To assign an extension to a Night Service group:
1LJKW6UYF H→*URXS$VVLJQ→([WHQVLRQV→Dial ext.
no. of Night Service operator
→(QWHU→Dial ext. no. of
member
→(QWHU→([LW→([LW
To assign a line to a Night Service group (Release 4.1
and later systems only):
1LJKW6UYF H→*URXS$VVLJQ→/LQHV→Dial ext. no. of
Night Service operator
→ →Dial outside line no.
(801–880)
→→ →
PC Procedures To assign a calling group to a Night Service group:
→→→Type ext. no. of Night Service
operator
→→Type calling group no.→→→
To assign an extension to a Night Service group:
→→→Type ext. no. of Night Service
operator
→ →Type ext. no. of member→→
→
To assign a line to a Night Service group (Release 4.1
and later systems only):
→→→Type ext. no. of Night Service
operator
→ →Type outside line no. (801–880)→
→ →
To Next Page
Loading...
Need help?
General
