EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 System Manager's Guide

Lucent Technologies MERLIN LEGEND Release 6.1
477 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
MERLIN LEGEND Communications System Release 6.1
System Manager’s Guide
555-661-118
Issue 1
August 1998
Read This First
Page 1-7Environmental Requirements
1
Environmental Requirements 1
The control unit requires a regulated environment that is temperature-controlled,
clean, and not exposed to direct sunlight. In addition, proper power and grounding
are essential for correct and safe system operation, and to protect the system
from lightning, power surges, and other problems.
If the control unit and other system components were installed by qualified Lucent
Technologies technicians, these requirements were met during installation.
After installation, you can help the correct operation of the system by making sure
the following rules are observed:
The electrical outlet for the control unit must not be controlled by a switch.
Plugging the control unit into an outlet that can be turned on and off by a
switch invites accidental disconnection of the system.
The AC outlet must be properly grounded by using an AC receptacle for a
3-prong plug.
Do not install the control unit outdoors.
Do not place the control unit near extreme heat (furnaces, heaters, attics,
or direct sunlight).
Do not expose the control unit to devices that generate electrical
interference (such as arc welders, or the motors of air conditioners,
ventilators, compressors, and so on).
Each auxiliary power unit requires one outlet.
Do not expose the control unit to moisture, corrosive gases, dust,
chemicals, spray paint, or similar material.
Do not place anything that could block ventilation on top of or around the
carriers.
Do not install the control unit under any device that may drip fluid, such as
an air conditioner.
For maintenance purposes, the control unit should be mounted in an
accessible location. There should be sufficient room and lighting available
to remove the cover(s) and replace modules without moving furniture,
boxes, or other objects.
For more information, contact your Lucent Technologies representative.

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals