MERLIN LEGEND Communications System Release 6.1
System Manager’s Guide
555-661-118
Issue 1
August 1998
System Capacities
Page C-7
C
Delay announcements per group.
In Release 5.0 and later systems, a group can
have 10 primary delay announcements and one secondary delay announcement.
Coverage Groups
Senders per group
. QCCs cannot be senders.
CTI (Computer Telephony Integration) Link (Release 5.0 and later systems)
Extensions per link
. Determined by types of telephones used. Maximum of 136
applies when all telephones are analog multiline; when all are MLX telephones,
the maximum is 127.
Extension jacks required.
The link requires an extension jack on an MLX 008 or
408 GS/LS MLX module; the module must not be of firmware vintage 29.
Fax Machines with Message Waiting
The system can support more than 16 fax machines, but those in excess of 16
cannot use the fax message-waiting indication.
System Operator Consoles
DLCs
(Direct-Line Consoles). Two consoles are allowed for each MLX or analog
module, with a maximum of eight per system. Up to two Direct Station Selectors
(DSSs) can be attached to an MLX operator console, and one is built into the
MERLIN II System Display Console.
Ports (not achievable simultaneously)
Speed Dial
Personal Speed Dial
. Single-line and 5- or 10-button telephones only.
System Programming Equipment
Remote access overrides on-site programming except during backup or restore.
Voice-mail interface Although the system software supports up to 24
voice-mail interface (VMI) ports, all the VMI
ports must be in the same calling group, and
the maximum number of extensions in a calling
group is 20.
Paging Software real-time limits, loop-start only
Delay announcements Maximum number of single-line extension jacks
(if these are used to connect delay
announcement devices)
To Next Page
Loading...
Need help?
General
