ENGINE SYSTEM
Air Intake Silencer
Prefilter Verification
Ensure that air intake silencer prefilter
is prope r ly installed and in g oo d condi-
tion, replace if damaged.
Filter
Cooling System
Check coolant level at room tempera-
ture. Liquidshouldbeatcoldlevelline
(engine cold) of coolant ta nk.
NOTE: When checking level a t low
temperature it may be slightly lower
then the mark.
If additional coolant is necessary or if
entire system has to be r efilled, refer
to an authorized LYNX dealer.
mmo2007-009-010_a
TYPICAL
1. Coolant tank
2. CO LD LEVEL line
Exhaust System
The tail pipe of the muffler should be
centered with the exit hole in the bot-
tom pan. Exhaust system must be
free of rust or leaks. Make sure that
gear clamps are properly tightened.
The exhaust system is d e s ig ned to re-
duce noise and to improve the total
performance of the engine. Modifica-
tion m ay be in vio lation of local laws.
CAUTION: If any exhaust system
component is removed, modified
or damaged, severe engine dam-
age m ay result.
_____________________
101
To Next Page
Loading...
