EasyManua.ls Logo

Lynx RaveTM RE 600 E-TEC - Engine Cut-Out Switch

Lynx RaveTM RE 600 E-TEC
134 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING SIGNALS
BEEPER DISPLAY MESSAGE
DESCRIPTION
2shorts
WELCOME...
Personalized welcome message, good key
Slow short beeps/
repetitive
CHECK KEY
Unable to read key
(bad connection)
Make sure the key
is free of dirt o r
snow. Reinstall key
and restart engine.
Vehicle can not be
driven.
Fast short beeps/
repetitive
BAD KEY
Invalid key or
key not programmed
Use the prop er key
for this ve hicle
or have the key
programmed.
Vehicle can not be
driven.
15) Engine Cut-Out Switch
Push-pull type switch. To stop the en-
gine in an emergency, select OFF posi-
tion (down) and simultaneously apply
the brake. To restart, button must be
at the ON position (up).
mmo2007-009-038_a
OFF POSITION
mmo2007-009-038_b
ON POSITION
All operators of the snowmobile
should f am iliarize themselves w ith
the fun ction of this device by using
it several times on first outing and
whenever stopping the engine there-
after. This engine cut-out procedure
will becom e a reflex and will prep are
operators for emergency situations
requiring its use.
WARNING
If th e sw itch has be en used i n an
emergency caused by a suspect-
ed malfunction, the source of the
malfunction should be determined
and corrected before restarting
engine. See an authorized LYNX
dealer for servicing.
54
______________________

Table of Contents

Related product manuals