E-TEC 600 HO engin e
PILOT
LAMP(S) ON
BEEPER DESCRIPTION
Continuous
fast short
beeps
Engine, muffler or ECM i s/are overheating, engine is
limited to 5500 RPM. Stop engin e as soon as possible
and allow components to cool. Check cooling system.
Continuous
fast short
beeps
– Critical low injection oil level. Stop vehicle in a safe
place as soon as possib le then, replenish injection
oil reservoir be fore restarting engine.
– If oil injection level is high, it then indicates a
failure of the oil i njection system, see an authorized
LYNX dealer as soon as possible.
4 short beeps
Engine, muffler or ECM is/are overheating, reduce
snowmobile speed and r un in loose snow or stop engine
and allow components to cool. Check cooling system.
4 short beeps
Engine management system fault that can change the
normal ope ration of the engine, see an authorized LYNX
dealer as soon as possible.
4 short
beeps every
2minutes
– E ngine under protection mode.
– E nsure recomm ended fuel is used.
– Check fuel quality, replace if necessary.
– If fault still occurs, contact an authorized LY NX dealer.
Continuously
beeps
– Engine shutdown procedure in force due to an
overheating during too long idle.
– F uel pump problem, contact an authorized
LYNX dealer.
4 short
beeps every
2minutes
Injection oil level is low. Replenish injection oil reservoir
as soon as possible.
—
Low fuel level. One (1) bar left in fuel level display.
Replenish fuel tank as soon as possible.
Slow long
beeps
Electronic reverse is selected.
3 short beeps Engine rotation did not change after reverse try, try again.
—
Headlamp is in HI beam position.
DESS
Refer to DES S PILOT LAMP CODES in TETHER CUT-OUT SWITCH.
48
______________________
To Next Page
Loading...
