oilreservoir
TYPICAL
1. Injection oil reservoir
2. L evel marks (1/4, 1/2, 3/4)
WARNING
Do not overfill. Reinstall cap and
fully tighten. Wipe off any oil
spills. O il is highly flammable
when heated.
RECOMMENDED INJECTION OIL
XP-S synthetic oil (P/N
619590100)
(2) (3)
XP-S synthetic blend (P/N
619590103)
(2) (3)
XP-S mineral inj ection oil
(4)
ENGINES
593SS
XXX
600 HO E-T EC
—
X
(1)
X
800R Power TEK
—
X
(1)
X
(1)
Prefered.
CAUTION:
(2)
XP-S synthetic oil and
XP-S synthetic blend oil are special-
ly formulated and tested for the se-
vere requirements of the 600 HO
E-TEC and other engines. Use of
any other brand two-stroke oil may
void the limited warranty. Use only
XP-S synthetic oil or XP-S synthetic
blend. There is no known equiva-
lent on the market for the m oment.
If a h igh q uality equivalent were
available, it could be used.
(3)
XP-S synthetic oil and XP-S
synthetic blend injec tion oil are
compatible, they can be mixed
together.
CAUTION: Never use four-stroke
petroleum or synthetic motor oil
and never mix these with out-
board motor oil. D o not use NMMA
TC-W, TC-W2 or TC-W3 outboard
two-stroke engine oils or ashless
two-stroke engine oils. Avoid m ix-
ing different brands of API TC oil as
resulting che mical reactions may
cause severe engine damage.
XP-S Mineral In jection
This is a special blend of basic oil and
additives specially selected to ensure
unequalled lubrication, engine cleanli-
ness and minimum spark plug fouling.
XP-S Synthetic and XP-S
Synthetic B lend Oil
The XP-S synthetic blend and XP-S
synthetic oil provides superior lubri-
cation, reduced engine component
wear and oil deposit, thus m aintaining
maximum-level performance and an-
tifriction properties. These synthetic
and synthetic blend injection oil meets
the latest ASTM and JASO standards
by ensuring hig h bio degradability and
low exhaust smoke.
64
______________________
To Next Page
Loading...
