MacDon 960 - Header Controls; Header Lift Cylinder Stops; Reel Props

HEADER OPERATION
HEADER CONTROLS
A
CAUTION: Be sure all bystanders
are clear of machine before starting
engine or engaging any header
drives.
See your Windrower Tractor or Combine
Operator's Manual for identification of
in-cab
controls for:
Header Drive Clutch
Header Height
Ground Speed
Reel Speed
Reel Height
HEADER LIFT CYLINDER STOPS
REEL PROPS
Reel props are located at each reel support arm.
WARNING: To avoid bodily injury
from fall of raised reel, always
engage reel props before going
under raised reel for any reason.
A
A
DANGER: To avoid bodily injury or
death from fall of raised header,
always engage cylinder stops
before going under header for any
reason. See your Windrower Tractor or
Combine Operator's Manual for instruction
regarding the use and storage of header lift
cylinder stops.
REEL PROP - ENGAGED
To engage reel props:
1. Raise reel to maximum height.
2. Move props (B) to engaged position.
3. Lower reel until props contact end frames.
NOTE: Keep pivot bolt (C) properly tightened so
prop remains in stored position when not in use,
yet can
be engaged with hand force.
For 36 foot header, be sure hose is positioned to
pass through slot
(0) in center arm prop.
36 FT. CENTER ARM
REEL
PROP-ENGAGED
16