TRANSPORT
Gauge Wheels
f Transport Option
2.
Raise header fulty.
CONVERTING
FROM
FIELO
POSITION
TO
TRANSPORT
1.
Move reel
fully
back
on
support arms. See
"Reel Position - Fore &
Aft"
for adjustment
details.
~
.-'_.-'
RIH
WHEEL
BEAM
- TRANSPORT POSITION
DANGER:
To
avoid
bodily
injury
or
death from unexpected start-up
or
fall
of
raised header,
stop
engine,
remove
key
and engage header lift
cylinder
stops
before
going
under
header
for
any
reason.
A
Some
30
and
36
foot headers
are
equipped
with
the transport option which allows pivoting the
gauge wheels 90" to allow towing the header
sideways.
At
RJH
end:
3.
Remove
l-pin
(L) at RlH
wheel
support,
lower
wheel beam and place L-pin
in
storage
position
as
shown.
4.
Remove hair pins
and
bar (0) from field
position
(in
welded plates
on
beam).
Rotate wheel beam 90" to position under
header
as
shown.
5.
Raise cutterbar support (E) fully. (Top edge
of support should be directly beneath guard
bolts.)
6.
Position head
of
bar (F)
on
anchor (G). Install
bar
(0)
(removed
in
step 4) and secure with
two hairpins.
NOTE: Head pivots
on
bar (F) to allow proper
frt
in
all applications.
Do
not over·tighten pivot
hardware.
At UH end:
7.
Remove pin (B) from field position at left
wheel support and remove
pin
(A), allowing
caster to lower, Rotate wheel 90° to under
side of header.
a.
Raise wheel support up to about 45°. Install
pin (B) in conversion position
as
shown
(through support and spring plate).
LEFT WHEEL SUPPORT -
CONVERSION POSITION
31
To Next Page
Loading...
