MacDon 960 - Divider Angle; Shut-Down Procedure

HEADER OPERATION
Operating Variables
DIVIDER ANGLE
The dividers can be angled in or out to provide
proper separation and
dean entry in a variety of
crops. Divider gather is factory set at approx-
imately 1.5 inches (40 mm). In tangled crops like
canola.
it may be necessary to reduce gather.
To adjusl angle, loosen hardware (A), posttion
divider and tighten hardware.
NOTE: On left side, ensure that front hinge pin of
side shield remains covered.
DIVIDER ANGLE ADJUSTMENT
Shut Down Procedure
CAlmON: Before leaving operator's see! for any reason:
1. Pari< 00 _ ground Wpossible.
2. Lower the head ... and reel fully.
3. Place all controls in NEUTRAL or PARK
4. Disengage head ...drive.
5, Engage
the part< brake.
6.
Stop engine and remove key from ignition.
7. Wait for all movement to stop.
25