SAFETY
SIGNAL
WORDS
Note the use
of
the signal words DANGER, WARNING and CAUTION with safety messages. The
appropriate signal word
for
each message has been selected using the following guidelines:
A DANGER
A WARNING
A CAUTION
SAFETY
SIGNS
- an immediate
and
specific hazard
or
forbidden
practice which WILL result
in
severe personal
Injul'y
or
death
If
the
message
is
not
followed.
- a specific hazard
or
unsafe
pradice
which
COULD
result
In
severe personal injury or
death
if
the
message is not followed.
- unsafe practice which
COULD
result In
per~
sonal injury
if
the message
is
not followed,
.
or
a reminder of good safety practices.
• The safety signs reproduced on the next page appear on the header at
the
locations listed.
• Keep safety signs clear and legible
at
all times.
Replace safety signs that
are
missing or become illegible.
If original parts
on
which a safety sign
was
Installed
are
replaced, be sure the repair part also bears
the
current safety sign.
• Safety signs are available from your Dealer Parts Department.
To
install safety signs:
1.
Be
sure
the
installation area is clean and dry.
2.
Decide on the exact positIon before you remove the backing paper.
3.
Remove
the
smaller portion of the split backing paper.
4.
Place the sign in position and slowly peel back the remaining paper, smoothing the sign as
it
is applied.
5.
Small
air
pockets
can
be
smoothed
out
or
pricked
with
a
pin.
5
To Next Page
Loading...
