MacDon 960 - Page 76

UNLOADING & ASSEMBLY
HYDRAULIC REEL FORE·AFT KIT
INSTALLATION INSTRUCTIONS
2. Attach cylinder(s) at:
- UH reel support arm (21',25' 30' Headers)
- UH and RlH reel support arms (36' Header) - UH shown
CLEVIS PIN. FLATWASHER (2)
& COTTER PIN
NOTE: INSTALL WITH CLEVIS
PIN HEAD ON INBOARD SIDE
DRILL HOLES IN ARM AS SHOWN BELOW
IF THEY ARE NOT ALREADY PRESENT
• INSTALL
3/8 NC x 1 1/4 HEX HD. BOLT
• INSTALL
& TIGHTEN HEX NUT
- INSTALL BAR
& FLANGE NUT
- SLIDE REAR CYLINDER SUPPORT INTO PLACE
'- SAME ASSEMBLY AND
ADJUSTMENT AS DRIVE
ARM (SEE PAGE
1)
SPACER
rr- FLAT WASHER
NOTE: DO NOT INSTALL BOTTOM WASHER
WHEN INSTALLING
ON PICK-UP REEL
~f--/~-=-;=::~=====::::~::::::::~~)-I-- BAR
A_-_ -=-= =.A
3/8 NC x 1·1/4 CARR. BOLT & FLANGE NUT.
. REINSTALL REFLECTOR (BAT REEL ONLY)
CLEVIS PIN
&
lID COTTER PIN
3/8 NC x 3·1/4
HEX HD. BOLT
& FlANGE NUT
3/8 NC FLANGE NUT j
3/8 NC x 1-1/2 CARR BOLT
HOLES CENTERED
ON ARM
1--300 mm:-l
I 11-13/16 In.
32 mm I
1·1/4 in.......... ~
o c::=-=-=-~--=-= ==.
DRILL .406 DIA. HOLES (2)
-----
o 0
r
M
REEL UFT CYUNDER PIN
74