41
Figure 33 - Difference Mode
2) Press and release the M/OFF button (step 2) to collect the second measure-
ment into memory. The indicator will then flash the number “3” icon and display
the difference result (Reading 1 - Reading 2).
3) Pressing and releasing ZERO/ON toggles between difference result and the
centerline result [(1+2)/2]. The indicator will flash the “123” icon for the center-
line result and the “3” icon for the difference result.
4) Press and release the M/OFF button (Step 3) to reset the indicator for the next
set of measurements. The indicator will then flash the number “1” icon and
return to a live display.
NOTE: The indicator remains in the Difference mode cycle until it is disabled by changing
the setting in the setup menu (M1 X1).
NOTE: Depending on the output configuration each M/OFF button press sends each mea-
surement and result or just the result data.
Step 1
Step 2
Step 3
Collect
Location 1
Measurement
Collect
Location 2
Measurement
Display
Difference
Result
Reset
Indicator
1
2
3
To Next Page
Loading...
Need help?
General
