62
Program codes are factory installed and labeled left-to-right on the indicator. When order-
ing special indicators the program code must be specified along with the indicator order
number. The program code must be clearly visible and follow the listing structure as pro-
vided here.
10.2 Lockout Password
Some program option lockout features are accessible by entering a password. The indica-
tor will prompt for the password anytime the locked feature is being accessed. When this
occurs the display appears as follows:
Figure 47 - Lockout Password Prompt
The password is entered in the same manor the preset or tolerance values are entered.
The inch/mm and ZERO/ON buttons are used to change the digits. The M/OFF button is
used to accept the entry when ready to do so.
The factory password is fixed and should not be provided to operator level personnel. The
password may be obtained by calling the factory direct at 1-800-343-2050. An example of
a numeric password is shown here.
Figure 48 - Password Sample
A PASS.Err prompt appears when the password is entered incorrectly. The indicator is
designed to allow for three attempts at entering the password. Upon the third incorrect
To Next Page
Loading...
Need help?
General
