18
5.1 Changing Measurement Direction (M1) [S]
1) Simultaneously press and hold M/OFF (1), then quickly press and release inch/
mm (2) once to enable the setup mode. (M1 icon appears in the lower left cor-
ner of the LCD) (Figure 1).
Figure 1 - Entering the Set-Up Mode
2) Press and release ZERO/ON to select the desired measurement direction signi-
fied by the “R” icon for reverse mode and no icon for the normal mode (Figure
2).
Figure 2 - Changing Measurement Direction
3) Press and release M/OFF until it returns to the gaging mode. No “Mx” icon is
displayed. Where “x” could be 1, 2, 3, 12, 23, etc.
To Next Page
Loading...
Need help?
General
