A
6 05.03
Introduction
CHAPTER
PAGE ISSUE
CHASSIS
ENGLISH
SECTION 1
A - CHASSIS
ABBREVIATIONS
Note:
the letter V in the illustrations refers to retaining or adjusting screws. The number following this letter refers to the
number of the same type of screw in the unit or component described and illustrated. Letters not followed by a
number indicate a single screw. In case of different screws being referred to in the illustration, the letter V is
followed by a number and a small letter, for instance: (V4a).
Unless otherwise specified, units and components are reassembled by proceeding in the reverse order of re-
moval.
F Figure
Cs Tightening torque
P Page
Pr Paragraph
S Section
Sc Diagram
T Table
V Screw
To Next Page
Loading...
