EasyManua.ls Logo

Malaguti XTM 50 - GENERAL SAFETY GUIDELINES; FIRE AND EXPLOSION WARNINGS; OPERATIONAL SAFETY GUIDELINES

Malaguti XTM 50
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A
8 05.03
Introduction
CHAPTER
PAGE ISSUE
CHASSIS
ENGLISH
SECTION 1
A - CHASSIS
F. 4
A
Never use open flames for any reason.
Never leave open containers or containers not suitable for holding fuel in passageways, close to heat
sources, etc
Never use petrol to clean the vehicle or the floor of the workshop. Always use low flash point solvents to
clean the vehicle components.
Never suck from or blow into the fuel pipe.
When welding, make sure that there are no flammable liquids in the vicinity. Always remove the tank, even
if completely empty, and disconnect the negative cable (-) from the battery.
Never leave the engine running in closed or poorly ventilated areas.
Before any servicing, make sure that the motorbike is perfectly stable.
The front wheel should preferably be anchored to the equipment (A - F.4) integral with the lifting board.

Related product manuals