2 - 65
6 - FORCED MODE OF THE ATTACHMENT CIRCUIT
t
IMPORTANT
t
By default, the attachment circuit in continuous mode is disabled as soon as the operator leaves the driver’s cab.
This condition can be changed from the OPT menu on the menu screen.
ATTACHMENT CIRCUIT UNLOCKED (by default)
ATTACHMENT CIRCUIT LOCKED
•
It is recommended to use this function when the telehandler is not fitted with hydraulic attachment.
ATTACHMENT CIRCUIT IN CONTINUOUS MODE
•
The indicator
will light when it is in use.
The operating screen displays the enabled mode. Press
or button to display the other available mode(s).
ADJUSTING THE ATTACHMENT CIRCUIT HYDRAULIC FLOW RATE IN CONTINUOUS MODE
- The pictogram
flashes, and switches to the setting screen
as soon as hydraulic flow rate is selected
using button A on the attachment hydraulic control lever.
- Button A forward for positive percentage (+ XX %), backward for negative percentage (XX %).
- Hold button A in the same position for 4 seconds to confirm the chosen hydraulic flow rate
.
- Press button or activate button A to return to the screen
88°
88
with flashing symbol, then deactivate the continuous mode.
- Buttons B and C limit the attachment hydraulic flow (e: 2 – DESCRIPTION: 18 -
HYDRAULIC CONTROLS).
CHANGE MODE
88°
Press
1
2
1
2
Confirm
88°
88
88°
88
Cancel
88°
88
88°
Press
1
2
1
2
Confirm
88°
88
88°
88
Cancel
88°
88
88°
Press
1
2
1
2
Confirm
88°
88
88°
88
Cancel
88°
88
2
To Next Page
Loading...
Need help?
General
