3 - 12
Ü
10 HOUR - DAILY MAINTENANCE OR EVERY 10 HOURS OF SERVICE
CHECK Area around the lift truck
Carry out a general inspection of the area surrounding the lift truck:
- Any leaks or liquid stains on the ground.
- Additional items on the lift truck and in the cab.
- Fixing and locking of the attachment.
- Fixing and adjustment of rear-view mirrors.
- Condition of the tires, to detect cuts, blisters, wear, etc.
t
IMPORTANT
t
Follow the operator instructions (e 1 - INSTRUCTIONS AND SAFETY PRECAUTIONS: OPERATOR INSTRUCTIONS).
CLEANLINESS OF THE LIFT TRUCK
- Cleanliness of lights and rear-view mirror.
- Excessively dirty or build-up of material (e.g. straw, flour, sawdust, organic waste, etc.).
- On a daily basis, and according to the conditions of use, the operator must ensure that the lift truck is in a clean condition.
- Particular attention should be paid to any build-up of flammable materials (e.g. straw, flour, sawdust, organic waste, etc.)
and lubricant or fuel leaks, which significantly increase the risk of fire breakouts.
- A regular inspection of the whole lift truck, particularly the engine housing and the central area of the chassis, should be
made to establish the cleaning frequency required to prevent potential build-up of material or spillages.
CHECK I.C. engine oil level
Place the lift truck on level ground with the I.C. engine stopped and let the oil settle in the crankcase.
- Open the engine bonnet.
- Pull out the dipstick 1.
- Clean the dipstick and check that level is between the two reference points.
- If necessary, add oil (
e LUBRICANTS AND FUEL) through the filler port 2.
- Visually check the I.C. engine for leaks or seepage of oil.
CHECK Coolant level
Place the lift truck on level ground with the I.C. engine stopped, and allow the engine
to cool.
t
IMPORTANT
t
To avoid any risk of spraying or burning, wait until the I.C. engine has cooled down before removing the cooling circuit
filler plug.
In an emergency, you can use water as a cooling liquid, then change the cooling circuit liquid as soon as possible.
- Open the engine bonnet.
- The fluid must be at the MAXI level in expansion vessel 1.
- If necessary, add cooling liquid (e LUBRICANTS AND FUEL) through the filler port 2.
- Visually check the radiator and pipes for leaks.
649100 EN-US-AU (20/05/2019)
MLT 961-145 V PLUS L JD ST4 S1
To Next Page
Loading...
Need help?
General
