Manitou MLT 961-145 V PLUS L JD ST4 S1 - Page 140

3 - 32
REPLACE Gearbox oil
CLEAN Speed sensor
t
IMPORTANT
t
Operation to be carried out the first time after 100 hours of service, periodically every 1000 hours of service.
Position the truck on level ground, with the engine switched off and the oil in the gearbox still hot.
Place a container under the drainage plug 1 (E11).
Unscrew plug 1 (E11) and let the oil flow out.
Remove the filler plug 2 (E11) to ensure complete drainage.
Refit the plug and tighten it 1 (E11) (35-50 N · m).
Speed sensor cleaning 5 (E11/1):
Loosen the screw and remove the speed sensor 5.1 (E11/1).
Loosen the screw and remove the speed sensor 5.2 (E11/1).
Install the speed sensor (Loctite 270), and tighten the screw to a torque of 9.5 - 11 N·m 5.3 (E11/1).
Install the speed sensor (Loctite 270), and tighten the screw to a torque of 9.5 - 11 N·m 5.4 (E11/1).
Fill the cup with the right quantity of new hydraulic oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through the filler
hole 3 (E11).
Refit the filler plug 2 (E11) (35-50 N · m).
When the oil is hot, check the level and top up, if necessary.
The level is correct when the oil level is flush with the edge of the hole 3 (E11).
Check for leakage from the drainage plug 1 (E11).
Loctite 270
9,5 - 11,5 N·m
Loctite 270
9,5 - 11,5 N·m
2
3
1
5.1
5.2
5.3
5.4
5
5
5
E11
649100 EN-US-AU (20/05/2019) MLT 961-145 V PLUS L JD ST4 S1