Manitou MLT 961-145 V PLUS L JD ST4 S1 - Page 150

3 - 42
REPLACE Alternator belt
- Open engine bonnet and the lower cover 1.
- Remove the guard 2.
- Place a 1/2" socket wrench in the square of the automatic tensioner 3 to slacken
the belt and remove it.
- Release the force and remove the socket wrench.
- Refit a new alternator belt (see: 3 - MAINTENANCE: FILTER ELEMENTS AND BELTS)
ensuring that it is properly seated in the grooves of each pulley and tighten the
belt using the automatic tensioner 3.
NOTE: Take advantage of belt removal to check the correct operation of the pulleys
and bearings (noise, rubbing, play, etc...).
- Reassemble the guard 2.
3
2
1
649100 EN-US-AU (20/05/2019) MLT 961-145 V PLUS L JD ST4 S1