1 - 19
SETTING DOWN A HIGH LOAD ON TYRES
- Approach the load in the transport position in front of the stack (fig� F6)�
- Apply the parking brake and place the forward/reverse selector in neutral�
- Raise and extend the jib (1) (2) until the load is above the stack, while monitoring
the longitudinal stability limiter and warning device (
e IINSTRUCTIONS FOR
HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE)� If
necessary, move the telehadler (3) forward (fig� F7), driving very slowly and carefully�
- Place the load in a horizontal position and lay it down on the pile by lowering and
retracting the jib (1) (2) in order to position the load correctly (fig� F8)�
- If possible, release the fork by alternately retracting and raising the jib (1) (fig� F9)�
Then set the forks into transport position�
- If this is not possible, reverse the telehadler (1), manoeuvring very slowly and
carefully to release the forks (fig� F10)� Then set them into transport position�
F6
1
2
3
F7
1
2
F8
1
F9
1
F10
To Next Page
Loading...
