1 - 30
IF THE TELEHANDLER IS NOT TO BE USED FOR A LONG TIME
INTRODUCTION
The following recommendations are intended to prevent the telehadler from being damaged when it is withdrawn from
service for an extended period�
t
IMPORTANT
t
Procedures to follow if the telehadler is not to be used for a long time and for starting it up again afterwards must be performed by your dealership. This long-term storage
period must not exceed 12 months.
After 12 months, perform the telehadler return to service and long term shutdown procedures again.
PREPARING THE TELEHANDLER
- Clean the telehadler thoroughly�
- Check and repair any fuel, oil, water or air leaks�
- Replace or repair any worn or damaged parts�
- Wash the painted surfaces of the telehadler in clear and cold water and wipe them�
- Touch up the paintwork if necessary�
- Shut down the telehadler (e OPERATING INSTRUCTIONS UNLADEN AND LADEN)�
- Make sure the jib cylinder rods are all in retracted position�
- Release the pressure in the hydraulic circuits�
DEF (Diesel Exhaust Fluid) TANK
Depending on the model of telehadler
- Drain and rinse the DEF tank�
- Replace the “DEF” (Diesel Exhaust Fluid) feed pump filter (e 3 - MAINTENANCE: 1000 HOUR - PERIODIC MAINTENANCE
- EVERY 1000 HOURS OF SERVICE OR EVERY 2 YEARS)�
- Slowly fill the tank with new “DEF” (Diesel Exhaust Fluid) up to the bottom of the filler neck�
- Start up the telehadler to pressurise the circuit and bring it up to working temperature, then shut down the engine�
- If necessary, top up the tank�
PROTECTING THE ENGINE
- Contact your dealer to obtain the procedure for protecting the inside of the engine (use of protection product)�
- Fill the fuel tank�
- Empty and replace the cooling liquid (e 3 - MAINTENANCE: 2000 HOUR - PERIODIC MAINTENANCE - EVERY 2000 HOURS
OF SERVICE OR EVERY 4 YEARS)�
- Leave the engine running at idling speed for a few minutes, then switch off�
- Replace the engine oil and oil filter (e 3 - MAINTENANCE: 500 HOUR - PERIODIC MAINTENANCE - EVERY 500 HOURS
SERVICE OR EVERY 1 YEAR)�
- Run the engine for a short time so that the oil and cooling liquid circulate inside�
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum�
- Block the outlet with waterproof adhesive tape�
- Remove the drive belts and store them in a safe place�
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection�
PROTECTING THE TELEHANDLER
- Set the telehadler on axle stands so that the tyres are off the ground�
- Release the parking brake (according to model of telehadler)�
- Protect cylinder rods which will not be retracted, from corrosion�
- Wrap the tires�
NOTE: If the telehadler is to be stored outdoors, cover it with a waterproof tarpaulin�
649100 EN-US-AU (20/05/2019)
MLT 961-145 V PLUS L JD ST4 S1