Turning loads
7.3 Turning a load
7 - 4 3 112 441 en Lattice extension operating instructions
GMK 4100/4100-L/5095
11.01.2008
7.3 Turning a load
When turning the load, proceed as is described in this section.
H
As soon as the load is attached to two hooks, there will be slight deviations
on the
Current load display. However, these deviations are still on the safe
side with regard to an SLI shutdown.
In principal, loads are turned with the auxiliary single-sheave boom top or
heavy load lattice extension in the same way as with the swing-away lattice
as illustrated in the following.
S
Risk of accidents due to overloading
Keep the acceleration forces to a minimum during two-hook operation.
For this reason, move the load at minimum speed.
To Next Page
Loading...
Need help?
General
