Additional pages GMK 4100 3 112 331 en 1
12.12.2008
Validity These additional pages are valid for all truck cranes GMK 4100 with the Lat-
tice extension operating manual
with one of the following identification num-
bers:
Reasons for the
additional infor-
mation
Swing-away lattice and boom extension
The values for the tables
Driving with rigged crane are available.
Integrated heavy load lattice extension: altered procedure
The specifications in the supplied Lattice extension operating instructions in
the chapter
Driving with rigged crane in the section Integrated heavy load lattice
extension (ISS)
are not applicable. Proceed as follows:
– The rigging modes and axle loads specified in these additional pages are
valid;
à Integrated heavy load lattice extension: ISS-A or ISS-B, p. 9.
• To move the crane on site, enter the SLI code for the current working
position with ISS in accordance with the lifting capacity table.
• Move the main boom and the lattice extension into the prescribed
position.
Auxiliary single-sheave boom top and heavy load lattice extension
The specifications in the delivered Lattice extension operating instructions
in the chapter
Driving with rigged crane for auxiliary single-sheave boom top
remain or heavy load lattice extension remain valid.
s
– 3 112 298 – 3 112 327 – 3 112 351 – 3 112 371 – 3 112 373
– 3 112 374 – 3 112 436 – 3 112 438 – 3 112 441 – 3 112 443
– 3 112 465 – 3 112 466 – 3 112 467
Driving with a rigged crane
To Next Page
Loading...
Need help?
General
