Masterflex I/P MASTERSENSE MFLX77421-00 - User Management

2-8 Masterflex
®
I/P
®
MasterSense™ Process Drives
Section 2: Basic Setup & Settings
Masterflex
User Management
 e I/P allows user access to be controlled using con gurable permission levels.
Default permissions:
• USER: Able to use basic pump drive functions and run programs.
• SUPER USER: Same level of access as USER but with the ability to create and modify programs.
• ADMIN: Full administrative access to the drive.
User and Super User permission levels
can be confi gured to allow access to diff erent Settings Menu items.
Default ADMIN username and password:
When switching on User Management for the fi rst time, or following a factory reset, you will be prompted
for a username and password. You must log in using the below default ADMIN user account details to
access user management settings.
Default username: admin
Default password: 123456
It is recommended that the default password be changed after logging in (see Editing an existing user below
for information on changing user passwords).
Con guring user lev el permissions:
1. Tap SETTINGS
from any of the mode screens.  e Settings Screen will be displayed.
2. SCROLL
through the Settings Screen pages to locate USER MANAGEMENT.
3. If required, tap the USER MANAGEMENT toggle to select ON.
4. Tap MODIFY USER.
5. Tap ACCESS LEVELS.
6. Tap USER or SUPERUSER.
7. Select the desired settings menu items to be included in the user level.
8. Tap CONFIRM
to save or CANCEL to discard any changes.
Adding a new user:
1. Tap SETTINGS
from any of the mode screens.  e Settings Screen will be displayed.
2. SCROLL
through the Settings Screen pages to locate USER MANAGEMENT.
3. If required, tap the USER MANAGEMENT toggle to select ON.
4. Tap MODIFY USER.
5. Tap NEW USER
.
6. Tap USERNAME and enter the new username using the onscreen keypad.
7. Tap PASSWORD and enter the desired password using the onscreen keypad. NOTE:  e password must
be at least six characters long.
8. Tap the required PERMISSION LEVEL. NOTE:  ere must always be at least one ADMIN user.
9. Tap CONFIRM
to save or CANCEL to discard any changes.