Masterflex I/P MASTERSENSE MFLX77421-00 - Cleaning the Pump Drive; Accessories; Replacement Parts

5-2 Masterflex
®
I/P
®
MasterSense™ Process Drives
Section 5: Service & Maintenance
Masterflex
CLEANING THE PUMP DRIVE
!
CAUTION: Unplug the pump drive’s power cable from the mains power outlet when cleaning
or performing maintenance on the drive.
If required, the pump drive may be wiped clean using a soft cloth lightly moistened with either isopropyl or
ethyl alcohol.
NOTE:
• Care should be taken with the pump drive’s touchscreen to avoid scratching or otherwise damaging the
surface. Do not wipe with dry or abrasive material.
• Do not operate the pump drive with water on the surface of the touchscreen.
• Any damage caused by improper cleaning will be the sole responsibility of the customer.
ACCESSORIES
To purchase accessories or for further information visit www.master ex.com.  e following accessories are
available for the I/P Process Drive:
Description Part Number
Footswitch (NEMA)* 07575-84
Interface Cable DB9M/DB9F 22050-54
Cable USB Type A/Type B M/M 22050-60
REPLACEMENT PARTS
Description Part Number
Fuse-T6.3 A, 5 x 20 mm B-1115-0054