Connectors on Matrox Solios GigE 161
You can connect to the JTAG connector with a standard Altera ByteBlaster II cable
that can be purchased from the Altera Corporation. To begin debugging, you must
first enable the connector by installing a jumper on the adjacent 2-pin connector
(J2).
For further information on debugging with the JTAG connector, refer to the
Quartus II documentation from the Altera Corporation. For other debugging
information, refer to the Matrox FPGA Developer’s Toolkit for Matrox Solios
manual.
To Next Page
Loading...
