Setup
Cabling
EPOS4 50/5 Hardware Reference
CCMC | 2023-07 | rel11726
3-17
MAKE&BAKE YOUR OWN
If you decide not to employ maxon’s prefab cable assemblies, you might wish to use the prepackaged kit
that contains all connectors required to make up your own cabling.
Table 3-8 EPOS4 Connector Set – Content
TOOLS
Table 3-9 Recommended tools
EPOS4 Connector Set (520859)
Connector Specification Quantity
Connectors
Molex Mega-Fit, 2 poles (171692-0102) 1
X1 / X2 Molex Mini-Fit Jr., 2 poles (39-01-2020) 2
X3 Molex Mini-Fit Jr., 4 poles (39-01-2040) 1
Molex Mega-Fit, 4 poles (171692-0104) 1
X4 Molex Micro-Fit 3.0, 6 poles (430-25-0600) 1
X6 / X16 Molex CLIK-Mate, dual row, 10 poles (503149-1000) 1
X7 / X9 Molex CLIK-Mate, single row, 8 poles (502578-0800) 2
X8 Molex CLIK-Mate, single row, 7 poles (502578-0700) 1
X10 Molex CLIK-Mate, single row, 5 poles (502578-0500) 1
X11 / X12 Molex CLIK-Mate, single row, 4 poles (502578-0400) 2
Crimp Terminals
Molex Mega-Fit, female crimp terminal (172063-0311) 7
X1 / X2 / X3 Molex Mini-Fit Jr. female crimp terminal (45750-1111) 9
X4 Molex Micro-Fit 3.0 female crimp terminal (43030-0010) 7
X6…X12 /
X16
Molex CLIK-Mate crimp terminal (502579-0100) 44
Accessories
X5 3M Retainer Clip with strain relief, height 13.5 mm (3505-8110) 1
Tool Manufacturer Part Number
Hand crimper for CLIK-Mate crimp terminals Molex 63819-4600
Hand crimper for Micro-Fit 3.0 crimp terminals Molex 63819-0000
Hand crimper for Mini-Fit crimp terminals Molex 63819-0900
To Next Page
Loading...