McCrometer ProComm - Factory Set Key Code; Converter Access Code

4.6 Converter Access Code
The access for programming the instrument is regulated by four access levels logically grouped. Every level is protected by
a dierent code.
Access levels 1-2-3-4 are freely programmable by user.
The code can be set by keypad or MCP
interface. Depending on the level of access,
it will be in the visual display functions.
These access levels determine which menu
functions are available for use depending
on the selected access level. See section 5.0,
"Menu Descriptions".
WARNING!
Take careful note of the customized code, since there is no way for the user to retrieve or reset it if lost.
!
Factory preset access codes:
L1 10000000
L2 20000000
L3 30000000
L4 40000000
L5 57291624
i
4.5 Factory Set Key Code
The converter is delivered with key code L1 = 10000000, and with the “Quick start menu” enabled. Press the Enter/Esc key.
The “Quick start" menu can be enabled or disabled.
ATTENTION!
It is very important to record any customized code as it CANNOT be retrieved
if it is lost!
13-SYSTEM
13.1 L1 code= ********
13.2 L2 code= ********
13.3 L3 code= ********
13.4 L4 code= ********
13.5 010.011.012.013
13.6 011.011.012.014
13.7 255.255.255.000
13.8 FW update
30124-60 Rev. 1.0 | unreleased
Page 16
CONVERTER OPERATION
ProComm
Preliminary