McCrometer ProComm - Menu 5 - Alarms

5.5 Menu 5 - Alarms
Menu
Position
Converter Function Code
Function
Name
Function Description
Access
Level
MCP
Command
5.1
[Max+=dm3/s]
Maximum
ow rate
threshold
direct
Sets the maximum value alarm
for direct ow rate setting. When
the ow rate value exceeds such
the threshold, an alarm message
is generated. The value of this
parameter is expressed as percentage
of the full scale value and may be
set from 0 to 125%. Setting this
parameter to zero corresponds with
disabling the alarm generation.
AL3 [FRAXP]
5.2
[Max-=dm3/s]
Maximum
ow rate
threshold
negative
Sets the maximum value alarm set
for reverse ow rate setting. When
the ow rate value exceeds such
a threshold, an alarm message
is generated. The value of this
parameter is expressed as percentage
of the full scale value and may be
set from 0 to 125%. Setting this
parameter to zero corresponds with
disabling the alarm generation.
AL3 [FRAXN]
5.3
[Min+=dm3/s]
Minimum
ow rate
threshold
positive
Sets the minimum value alarm set
for reverse ow rate set. When the
ow rate value falls below such a
threshold, then an alarm message
is generated. The value of this
parameter is expressed as percentage
of the full scale value and may be
set from 0 to 125%. Setting this
parameter to zero corresponds with
disabling the alarm generation.
AL3 [FRANP]
5.4
[Min-=dm3/s]
Minimum
ow rate
threshold
negative
Sets the minimum value alarm set
for reverse ow rate set. When the
ow rate value falls below such a
threshold, then an alarm message
is generated. The value of this
parameter is expressed as percentage
of the full scale value and may be
set from 0 to 125%. Setting this
parameter to zero corresponds with
disabling the alarm generation.
AL3 [FRANN]
30124-60 Rev. 1.0 | unreleased
Page 26
Menu Descriptions
ProComm
Preliminary