McCrometer ProComm - Menu 9 - Display; Menu 10 - Data Logger

5.9 Menu 9 - Display
Menu
Position
Converter Function Code Function Name Function Description
Access
Level
MCP
Command
9.1
[Language=EN]
Language for all
msn
Sets the language selection. There
are 2 languages available: EN =
English, IT = Italian.
AL1 [LLANG]
9.2
[Contrast=5]
Display Contrast
Sets the display contrast. The
contrast can change according
to the room temperature. The
allowed range is from 0 to 9.
AL1 [DCNTR]
9.3
[Disp.time=s020]
Keyboard
Timeout Time
Sets dispay/keyboard inactivity.
The set values are from 020 to 255
second.
AL1 [KBTMT]
9.4
[D.rate=Hz5]
Display Refresh
Frequency
Sets the frequency of the display
data update. This parameter
eects only the display layout
and not the response time of the
meter itself. The possible choices
are: 1/2/5/10 Hz.
AL1 [DISRF]
9.5
[Disp.fn=1]
Display function
number
Sets the display of the page
making it visible when you start
the display. Each display page is
associated with a number that
corresponds to Pos 9.5.
AL2 [DISFN]
9.6
[Disp.lock=ON]
Display function
lock
Locks display page sliding
selected by Pos 9.5.
AL2 [DLOKE]
9.7
[Part.tot.=]
Partial totalizer
This function enables the display
of partial totalizer in visualization
pages
AL2 [PTOTE]
9.8
[Neg.tot.=ON]
Negative totalizer
This function enables the
display of negative totalizer in
visualization pages
AL2 [NEGTE]
9.9
[Quick start=ON]
Quick start menu
This function enables the display
of date and time in visualization
pages
AL2 [QSTME]
5.10 Menu 10 - Data Logger
Menu
Position
Converter Function Code Function Name Function Description
Access
Level
MCP
Command
10.1
[D.logger en=
OFF]
Data logger
enable
Enables the data logger.
AL3 [DLOGE]
30124-60 Rev. 1.0 | unreleased
Page 32
Menu Descriptions
ProComm
Preliminary