McCrometer ProComm - Menu 13 - System

Menu
Position
Converter Function Code Function Name Function Description
Access
Level
MCP
Command
12.4
[Flow sim.=ON]
Flow Rate
Simulation
Enables ow rate simulation.
With this function, it is possible to
generate an internal signal that
simulates the ow rate and allows
for testing the outputs and all the
connected instruments.
AL3 [MSIEN]
After enabling it, a
▲▼
appears in the top left of the screen and the ow rate simulation can be:
• Set: Press Enter on one of visualization pages. This sets the required % ow rate (Fl. rate=%). Pressing the
Enter key conrms the value.
• Finished: Press Enter on one of the visualization pages and then make a long press on the same key.
12.5
[Firmware info]
Firmware Info
Shows the rmware info version/
revision (read only)
AL0 [DMVLS]
12.6
[S/N=999001]
Board Serial
Number
Shows the board serial number
(read only)
AL0 [DMVLS]
12.7
[WT=0002:21:00:22]
Working Time
Shows the instrument's total
working time (read only)
AL0 [TWKTM]
5.13 Menu 13 - System
Menu
Position
Converter Function Code Function Name Function Description
Access
Level
MCP
Command
13.1
[L1 code= ********]
Access level value
code 1
This function enables or disables,
for each access level code, the
main menu functions. Each level
unlocks the functionality of the
lower level.
--- [L1ACD]
13.2
[L2 code= ********]
Access level value
code 2
--- [L2ACD]
13.3
[L3 code= ********]
Access level value
code 3
--- [L3ACD]
13.4
[L4 code= ********]
Access level value
code 4
--- [L4ACD]
13.5
[010.011.012.013]
Device IP Address Device IP network address AL3 [DIPAD]
13.6
[011.011.012.014]
Client IP Address Client IP network address AL3 [CIPAD]
13.6
[255.255.255.000]
Network Mask Network mask AL3 [NETMS]
13.7
[FW update]
Firmware Update
This function enables rmware
update. The rmware can be
uploaded to the SD card (name.
le).
MCP interface is activated by the
command FWUPD = name.le
AL4 [FWUPD]
30124-60 Rev. 1.0 | unreleased
Page 36
Menu Descriptions
ProComm
Preliminary