McCrometer ProComm - Page 22

Menu
Position
Converter Function Code
Function
Name
Function Description
Access
Level
MCP
Command
1.14
[C.Curr.= mA
xxx.x]
Coils
Ex.Current
Sets the excitation coils current. This
function is active if the sensor model
is NOT present on the sensor's table
standard parameters.
AL4 [CEXCC]
1.15
[C.Reg.PB= xxx]
C. Reg. PB Sets the current regulator parameter.
This function is active if the sensor
model is NOT present on the sensor's
table standard parameters.
AL4 [CRPRB]
1.16
[C.Reg. DK = xxx]
C. Reg. DK Sets the current regulator parameter. AL4 [CRDER]
1.17
[S.Freq.= Hz xx]
S. Freq. Sets the measurement sampling
frequency.
AL4 [SFREQ]
1.18
[E.P.Detect= ON]
Empty Pipe
Detection
Enables the empty pipe detection
function.
AL3 [EPDEN]
1.19
[R max= Kohm
xxxx]
Empty pipe
D. Thresh.
Sets the maximum value of the
electrodes' resistance.
AL4 [EPDTH]
1.20
El.cleaning
Electrode
cleaning
Helps keep the electrodes clean.
The allowed values are OFF,
minimum, average and maximum.
It is not recommended to use
this function when the liquid has
a conductivity less than 100µS/cm
(set to OFF).
AL4 [ELCLN]
1.21
[S.cable=m xxx]
Sensor Cable Sets the length of cable between the
sensor and the converter on remote
mount converter.
AL4 [SCALN]
1.22
[S.err.delay=m
xxx]
Signal error
delay
Sets the delay or wait time before
an error generates an alarm. This
function is useful to prevent zero
“dropouts”of the ow signal caused
by sporadic events (empty pipe,
excitation error, signal error.
AL4 [SEALT]
1.23
[Sens. verify=
OFF]
Sensor verify Enables automatic sensor verication.
(See BIV optional function, section
6.4.)
AL3 [ASVFE]
1.24
[KL=00]
Automatic
sensor verify
enable
Sets coecient KL values AL4 [SETKL]
30124-60 Rev. 1.0 | unreleased
Page 20
Menu Descriptions
ProComm
Preliminary