McHale Fusion 3 - Chamber Losing Pressure; Issues with Bale Rotation;Intake; Issue with Bale Quality;Density; Machine Won’t Cut the Net

McHale Fusion 3 Baler & Wrapper
113
15.1.7 Chamber losing pressure
15.1.8 Issues with bale rotation/intake
15.1.9 Issue with bale quality/density
15.1.10 Machine won’t cut the net
Symptom Reason Solution
Chamber losing pressure Oil leak Find leak and resolve
Chamber losing pressure Relief valve loose /
restriction in relief
Contact dealer
Symptom Reason Solution
Baler won’t take crop in
even though the bale
chamber is not full
Drop floor down—this can
cause problems with bale
rotation
Reset the floor to the
working position
Baler won’t take crop in
even though the bale
chamber is not full (Straw)
The bale has stopped
rotating
Fit straw bar. (Available
from dealer).
Symptom Reason Solution
Issues with bale quality/
density
Density set too low for the
crop conditions
Increase the density
Issues with bale quality/
density
Crop build up at the
tailgate lower closing point
Clean away loose crop
Issues with bale quality/
density
Ground speed too high Reducing ground speed
will allow the machine to
pack the bale better.
Machine making bales
with soft edges/ corners
The centre of the bale is
being overfilled
See “Swath preparation”
on page 85
Symptom Reason Solution
Machine won’t cut the net Bill hook worn and
catching on plastic reset
bushing
Replace bill hook