McHale Fusion 3 - Chopper Knives Wont Move (Activate;Disengage); Net Not Cut Correctly; Drop Floor Wont Move (Up or Down) - Pick Up Moves

McHale Fusion 3 Baler & Wrapper
114
15.1.11 Chopper Knives wont move (activate/disengage)
15.1.12 Net not cut correctly
15.1.13 Drop Floor wont move (up or down) - Pick up moves
Machine won’t cut the net Bill hook has too much
free play and is catching
on the plastic reset
bushing
Realign
Machine won’t cut the net Knife jammed or not
enough spring pressure
Check for free movement
and increase spring
pressure if needed
Symptom Reason Solution
Knives won’t move
(activate/disengage)
Faulty hydraulic valve Contact dealer
Knives won’t move
(activate/disengage)
Low Power Supply to the
control box
Check power source
Symptom Reason Solution
Net not cut correctly Blunt/ rusty knife Fit new knife
Net not cut correctly Grease on Knife (new
machine/ machine after
winter storage)
Clean grease off knife
Use extreme caution and
protective clothing!
Net not cut correctly Knife spring too slack Adjust knife spring
pressure. (Located behind
the netter drive gears)
Symptom Reason Solution
Drop Floor won’t move (up
and or down)
Faulty hydraulic valve Contact dealer
Drop Floor won’t move (up
and or down)
Low Power Supply to the
control box
Check power source
Symptom Reason Solution