McHale Fusion 3 Baler & Wrapper
49
may be reset sooner, if desired, from within the control box sub menus. See “Control
box features” on page 60 for instructions on how this is done.
To add oil:
1. Unscrew the top cap and add chain oil to the oil reservoir tank (A), up to the
maximum level mark shown.
2. Replace the cap and tighten fully.
Replacing refill grease cartridge and releasing airlock:
McHale recommend using a multipurpose, extra high performance grease such Mobil
grease XHP222 or equivalent NLGI number 2 grade grease.
WARNING: Ensure the tractor is shut down before adding oil
Ensure that the tractor engine has been shut down, the key has been
removed from the ignition and the brakes have been applied before
adding oil.
NOTE: Oil filter needs to be replaced at least once every season
The oil filter, inside the oil reservoir tank, will need replacement once
every season or as soon as reduced oil consumption is noticed. The filter
is critical to proper operation and lubrication.
CAUTION: Avoid contact of the grease with skin
Avoid contact of the grease with skin
1. Unscrew the cartridge holder from
the pump and remove the used
cartridge
2. Pull the plunger all the way back
3. Remove the cap from the plunger
end of the refill cartridge. Insert the
refill cartridge, as shown
To Next Page
Loading...
